22
EN
DD52R-E-RF
Electronic position indicators
Data transmission via radio frequency
Models all rights reserved in accordance with the law.
Always mention the source when reproducing our drawings.
7.4 Direct programming of the absolute reference value (source) - of the
compensation value (offset) - of the reading after one revolution
The function of the keys combination allows direct access to the
programming of one of the following parameters, depending on the
value assigned to parameter
0 _ _ _ _ 0
.
It is possible to change the function of the keys combination
by setting the parameter
0 _ _ _ _ 0
The available options are:
-
P_OrG
: direct programming of the absolute reference value (OrG parameter)
-
P_StP
: direct programming of the reading after one revolution (StEP parameter)
-
P_OFS
: direct programming of the compensation value (OFFS parameter)
-
OFF
: the keys combination
+
is not associated to any function in
the operating mode
For programming the parameters listed above see parameter
0 _ _ _ _ 0
of
paragraph 8.2.
7.5 Programming the network parameter (nEt id) and the channel parameter
(nEt ch)
DD52R-E-RF indicators must be networked to the UC-RF control unit via radio
frequency. By selecting the network number to the PLC (see UC-RF manual),
select the parameter
rAdio
on the indicator.
The parameters to be set are:
-
nEt id
: id 0/9
-
nEt ch
:
ch 01/36
These parameters must be set according to the PLC recipe and guarantee perfect
communication between UC-RF and DD52R-E-RF.
7.6 Programming target position
The function of the keys combination allows, if the parameter
0 _ 0 _ _ _
has
been set on
tArGEt
, to program or to load one of the 32 target positions.
It is possible to change the function of the keys combination
by setting the parameter
0 _ 0 _ _ _
The available options are:
+
0 _ 0 _ _ _
0 _ _ _ _ 0
