elero UniTec-868, Руководство по эксплуатации

Страница: 5 / 8

GB-8
GB
Programming the radio
GB-7
Program the transmitter
Condition: The drive must be installed.
1. 1. With electrical, previously installed drives, turn the safety
fuse off and after a few seconds on again.
The receiver is now in programming mode for about 5 minutes.
2. Stand in front of the blind/shutter with the transmitter.
3. Open the cover on the front and press one of the programming
buttons P briefly.
The blind/shutter automatically travels briefly up and down
again and again for about 2 minutes.
4. To define the button assignment press the UP -button on the
transmitter immediately after the start of the up travel (1 sec.).
The blind/shutter will stop for a short time.
Immediately after the start of the down travel press the
DOWN -button on the transmitter.
The blind/shutter will stop.
The transmitter is now programmed.
Programming the radio
Programming further transmitters
If you wish to program other transmitters to a receiver you can pro-
ceed as follows:
1. On a transmitter, which has already been programmed to the
receiver, press the UP , DOWN and the programming button P
until the LED goes out.
2. To define the button assignment press the UP -button on the
transmitter immediately after the start of the up travel (1 sec.).
The blind/shutter will stop for a short time.
Immediately after the start of the down travel press the
DOWN -button on the transmitter.
The blind/shutter will stop.
The transmitter or this channel is programmed.
Advice: If several receivers are connected to the same feed line,
then all are simultaneously ready to program.
The roller shutter starts a “random” brief up/down trip.
The longer you wait with the programming the greater
will be the offset.
Individual transmitters can now be assigned to the
respective receiver.
You can stop the brief up/down travel by briefly pressing
the
STOP -button on a manual transmitter which has
already been programmed.
The channel assignment/change can now be made
without you having to disconnect the individual receivers.
If the roller shutter travels in the wrong direction, delete
the transmitter and reprogram it.
The last direction assignment by the transmitter is valid
for all transmitters which have been programmed in the
receiver.