Program transmitter/program end positions
AstroTec-868 bidi
EN-22
The AstroTec-868 bidi (item no. 28 320.
0006
) is a radio wall transmitter
for
exclusive use with bidirectional receivers
(use of the AstroTec-868
bidi with unidirectional transmitters and receivers is not possible – in this
case use please use the former AstroTec-868 (item no. 28 320.0001).
Programming/deletion of the radio transmitter
As long as the AstroTec-868 bidi has not been programmed for at least
one receiver, each press of a button results in an acoustic signal being
issued to inform you that programming must yet take place.
Programming the transmitter
Condition: the drive must be installed
1.
With electrical, previously installed bidirectional receivers, turn the
safety fuse off and after a few seconds on again. The actuator is
now in programming mode for a period of approximately 5 minutes.
2.
Position yourself in front of the roller shutter with the AstroTec-868
in your hand.
3.
Press the programming button P on the back of the device briefly.
The shutter will automatically begin to move up and down for
approx 2 minutes.
4.
In order to define the keyboard layout, press the UP button (front of
the device) on the AstroTec-868 bidi immediately (max. 1 second)
after beginning upward motion; the status of the bidirectional pro-
gramming is acoustically signalised.
The roller shutter stops briefly and then continues to travel again.
Press the DOWN button on the AstroTec-868 bidi immediately after
beginning downward travel; the status of bidirectional programming
is acoustically signalised.The roller shutter stops.
The AstroTec-868 bidi is now programmed.
AstroTec-868_AstroTec-868_bidi EN_0412.indd 22
stroTec-868_AstroTec-868_bidi EN_0412.indd 22
12.04.2012 17:31:14
12.04.2012 17:31:14
