Elenos E10000X, Руководство пользователя

Страница: 49 / 104

49 User instructions
Event Code Message Description
WARNING 034 TEMPERATURE SENSOR ERROR
If the thermal probes installed are more than
one, it means the fault of one of these because
its read value is significantly different from the
expected one�
ALARM 035 PWR FORWARD OSCILLATION
RF output power oscillation is detected and the
apparatus attempts the “Three Block Out” reco-
very protection�
ALARM 036 THREE BLOCK OUT
The malfunction has not disappeared during
the automatic protection time and the appara-
tus was stopped�
WARNING 037 USER ENV TEMP OUT LIMIT
The user-defined environmental temperature
limits in “User Alarms Data” have been excee-
ded�
WARNING 038 USER RF TEMP OUT LIMIT
The user-defined RF temperature limits in “User
Alarms Data” have been exceeded�
WARNING 039 USER PSU TEMP OUT LIMIT
The user-defined PSU temperature limits in
“User Alarms Data” have been exceeded�
WARNING 040 USER RF CURRENT OUT LIMIT
The user-defined RF current limits in “User
Alarms Data” have been exceeded�
WARNING 041 USER PSU CURRENT OUT LIMIT
The user-defined PSU current limits in “User
Alarms Data” have been exceeded�
WARNING 042 USER FRW PWR OUT LIMIT
The user-defined RF forward power limits in
“User Alarms Data” have been exceeded�
WARNING 043 USER RFL PWR OUT LIMIT
The user-defined RF reflected power limits in
“User Alarms Data” have been exceeded�
ALARM 044 OUT PWR NOT VERIFIED
The RF output power measurement is not re-
liable�
STATUS 045 UPS ACTIVE
The apparatus works by drawing current from
the UPS�
ALARM 046 SHUNT COMM TIMEOUT
Internal serial communication timeout� The ap-
paratus has stopped working�
WARNING 047 WARNING TEMPERATURE SENSOR
A thermal probe is unreliable and its reading
is discarded�
ALARM 049 DRAIN VOLTAGE TOO LOW
VDS voltage too low� The amplifier section has
been stopped and will remain so until the di-
sappearance of the cause�
WARNING 050 OVER FRW PWR ERROR
An overshoot of RF output power respect to the
target is occurred�
WARNING 051 PSU VOLTAGE DERATING One or more PSU are in voltage derating�
WARNING 052 PSU NET OVER VOLTAGE Mains voltage too high�
STATUS 053 PILOT PWR GOOD The RF input power level is correct�
WARNING 054 INCREASE PILOT PWR
The RF input power level is to low but not dan-
gerous and must be increased�
WARNING 055 DECREASE PILOT PWR
The RF input power level is to high but not
dangerous and should be decreased�
ALARM 056 BAD INPUT RF PROTECTION
RF input power level out of limit� The external
modulator has been disconnected�
WARNING 059 BATTERY LOW
The CPU backup battery is low� In case of no
mains, the clock will lose settings�
WARNING 060 REFERENCE VOLTAGE ERROR
The internal reference voltage is no longer re-
liable and the measurements will be incorrect�
Some wrong alarms or warnings could be sent�
WARNING 062 DRAIN VOLTAGE CONTROL ERROR
VDS voltage is more than 4V different from the
expected value� The adjustment is fixed at the
last valid value� It restarts when the difference
becomes less than 4V�
WARNING 065 RTC FAULT
The clock says a wrong time and it isn’t possible
to cerrect automatically� Some settings, such as
“clock power target”, will not run correctly�
STATUS 066 RTC USER UPDATED The user has updated the internal clock�
STATUS 067 RTC AUTOMATIC RECOVERY
The apparatus has updated the internal clock
automatically�