Elenos E10000X, Руководство пользователя

Страница: 48 / 104

48 User instructions
Event Code Message Description
STATUS 000 CORRECT WORKING
No error� The apparatus is working correctly�
The event “019 ON AIR” has an higher priority�
STATUS 001 SYSTEM RESET
The list of occurred alarms is under deleting
process� Active ones aren’t deleted�
WARNING 002 EEPROM CHKSUM ERROR
The data stored in memory is no longer relia-
ble� The apparatus will be restarted with de-
fault parameters�
ALARM 003 BLOCKED
The apparatus is blocked after that five resto-
re have been attempted� To restart it, a reset
command is required�
STATUS 004 STOP
The apparatus is in StandBy mode with no acti-
ve alarms, ready to work�
ALARM 005 -3dB CARRIER
The RF output power is less than half target po-
wer since one minute during the start up or five
seconds during the correct working�
ALARM 006 HIGH REF PWR
High reflected power is detected after that a
“Three Block Out” recovery protection has been
attempted�
ALARM 007 MIN 12V
The negative voltage reference is no longer re-
liable� The apparatus attempts the “Three Block
Out” recovery protection�
ALARM 008 RF AMP� FAULT
A failure is occurred in one or more RF amplifier
modules�
WARNING 009 RF AMP� FAULT DERATING
As above, but the RF output power is reduced
according to an algorithm�
WARNING 010 RF THERMAL DERATING
The temperature of one or more RF amplifier
modules is been too high so that the RF output
power is reduced according to an algorithm�
ALARM 011 RF OVER TEMPERATURE
The “RF THERMAL DERATING” failed and the ap-
paratus attempts the “Three Block Out” recove-
ry protection�
ALARM 012 PSU FAULT A PSU malfunction is occurring�
WARNING 013 PSU CURRENT DERATING
One or more PSU overloads are occurred so that
the apparatus is reducing the RF power output
according to an algorithm�
ALARM 014 PSU OVER CURRENT
The apparatus was shut down in a minute since
the current derating didn’t decrease�
WARNING 015 PSU THERMAL DERATING
One or more PSU overheatings are occurred so
that the apparatus is reducing the RF output
power according to an algorithm�
ALARM 016 PSU OVER TEMPERATURE
The temperature of one or more PSU have been
too high so that apparatus has been shut down�
ALARM 017 PSU COMM TIMEOUT
The RS485 internal bus dedicated to the com-
munication between CPU and PSU isn’t working
correctly�
STATUS 018 EXTERNAL INTERLOCK
The interlock circuit is open and the apparatus
is blocked�
STATUS 019 ON AIR The apparatus works correctly�
STATUS 020 POWER UP RF output power increase is occurring�
STATUS 021 POWER DOWN RF output power decrease is occurring�
WARNING 022 PSU THERMAL DERATING/FAULT
One or more PSU are performing a thermal de-
rating by reducing the current supplied�
WARNING 023 PSU LOW POWER
One or more PSU are in thermal derating so
that the RF output power is reduced�
ALARM 024 PSU RF OFF
The RF section has been turned off so that the
fans can quickly cool the apparatus�
STATUS 025 WORKING MODE COMBINED The apparatus works in a combined transmitter�
WARNING 026 SWR FOLDBACK
High reflected power has been detected so that
the apparatus is adjusting the RF output power
according to an algorithm�
STATUS 030 OVER 2/3 CARRIER
The RF output power is rising up to 2/3 of the
target after which a “-3dB” alarm has occurred�