Elenberg DW-9001, Инструкция по эксплуатации

Страница: 37 / 41

37
Cold Water Connection
Connect the cold water supply hose to a
threaded 3/4 (inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been
used for an extended period of time, let the
water run to make sure that the water is clear
and free of impurities. If this precaution is not
taken, there is a risk that the water inlet can get blocked and dam-
age the appliance.
Hot Water Connection
The water supply to the appliance can also be connected to the
house hot water line (centralized system, heating system),as long
as it does not exceed a temperature of 60°C. In this case, the wash
cycle time will be shortened by about 15 minutes and the wash ef-
ficiency slightly reduced.
The connection must be made to the hot water line following the
same procedures as those for the connection to the cold waterline.
Positioning the Appliance
Position the appliance in the desired location. The back should rest
against the wall behind it, and the sides, along the adjacent cabi-
nets or wall. The dishwasher is equipped with water sup ply and
drain hoses that can be positioned to the right or the left to facili-
tate proper installation.
Leveling the Appliance
Once the appliance is positioned, adjust
the feet (screwing them in or out) to ad-
just the height of the dishwasher, making
it level. In any case, the appliance should
not be inclined more than 2°.
Drain hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of
4 cm, or let it run into the sink, making sure to avoid bending or
crimping it. Use the special plastic support that comes with the ap-
pliance. The free end of the hose must be at a height between 40
and 100cm and must not be immersed in water.
WATER CONNECTION