Elenberg DW-9001, Инструкция по эксплуатации

Страница: 27 / 41

27
Wash cycle adjustment buttons
Plus Button
This button (see” Control panel”) is used with the normal cycle in
the case where pots and pans with dry caked-on food must be
washed.
This is not recommended for delicate items in so far as the high
temperature could make their surfaces opaque or lighten decora-
tive colors after repeated washing.
Rapid Button
This button (see” Control panel” (when pressed with wash cycle
4(glassware)makes it possible to run the wash cycle at a lower tem-
perature (50°C) and eliminates the drying phase.
Overfill Protection
Your dishwasher has an overfill protection device which could au-
tomatically shut off the inlet valve and starts the drain pump if the
water level in the unit is detected to be above the normal level. If
this occurs, turn off the main water supply before calling for servic-
ing. If there is water in the base pan because of an overfill or small
leak, the water should be removed before restarting the dishwash-
er.
IF YOUR MODEL HAVE NOT WATER SOFTENER, YOU MAY
SKIP THIS SECTION.
There are two ways to reduce the water hardness: one way is using
water softener, the other is using detergent.
The hardness of the water varies from place to place. If hard water
is used in the dishwasher, deposits will form on the dishes and
utensils.
The appliances is equipped with a special softener that uses a salt
specifically designed to eliminate lime and minerals from the wa-
ter.
Loading the Salt into the Softener
Always use salt intended for use with dishwash-
ers. The salt container is located beneath the
lower rack and should be filled as follows:
1. Remove the lower basket and then unscrew
and re move the cap from the salt container.
2. If you are filling the container for the first
time, fill 2/3 of its volume with water.
WATER SOFTENER