Elenberg DW-500, Инструкция по эксплуатации

Страница: 21 / 28

21
For best operating results, incoming water pressure should be be-
tween 0.3 and 10 bar.
FOR bEST RESULTS:
• Your dishwasher cleans by spraying a mixture of hot clean wa-
ter and detergent (under pressure) against the soiled surface of
dishes. The water is pumped through a rotating spray arm, drained
through a ilter removing food and soiled particles and pumped
back through the spray arm.
• Soiled water is pumped out and replaced with clean water at the
end of each cycle (the number of times depends on the cycle being
used). For best cleaning results, the water temperature must be at
least 130
0
F (55
0
C). To prevent dishwasher damage, the tempera-
ture of the incoming water supply should not exceed 160
0
F (71
0
C).
NOTE: Hard Water conditions will adversely affect wash ability perfor-
mance of your dishwasher. Hard Water conditions will also con-
tribute to “Lime” (white ilm substance) deposits and/or “Scaling” on
the stainless steel surface of the dishwasher tub and “Heater Ele-
ment” located in the sump underneath the removable ilter screen.
To assist in minimizing these conditions, it is recommended to pe-
riodically operate/rinse the inside of the dishwasher (empty) using
1 cup of white vinegar (at least once a week).
• Close the hot water supply at the stopcock.
• Disconnect the power supply cord.
• Disconnect the inlet hose assembly from the water supply. When
the dishwasher is not in use, place/store the hose on the hanger
hose bracket located on the rear wall of the dishwasher cabinet.
• Appliances that are to be discarded must be made unusable. Pull
off the plug, remove cable and make the door lock and latch unus-
able
IMPORTANT
Once you open the water supply line, (even if it is closed immedi-
ately there after) the water inlet hose will be pressurized.
CAUTION
DO NOT LET CHILDREN DISCONNECT THE DISHWASHER. Close su-
pervision of children is always important around appliances.
WATER PRESSURE
DISCONNECTING YOUR DISHWASHER