Elenberg DW-500, Инструкция по эксплуатации

Страница: 20 / 28

20
1. Remove all packing materials carefully
2. The water inlet hose from the machine terminates in a ¾” female
connector. The water supply should therefore terminate in a simi-
lar male connector and should have a stopcock close by in the
pipe. Connect the straight connector of the inlet hose to the water
supply securely. Connect the other end (bent connector) to the
water inlet valve at the back of the dishwasher cabinet. Do not
over-tighten to avoid damage to threads.
3. Prepare the drainage hose so that it has hooked end. Use the plas-
tic U-bend itting provided for this purpose. The end of this should
be dropped into a drainage standpipe, the maximum height of
which should be no more than 6” above the base of the dishwash-
er. To allow for an air gap around the end of the drain hose, the
diameter of the standpipe should be at least 30 mm. Connect the
other end of the drain hose (L shaped) to the drain port connection
at the back of the dishwasher cabinet. Tighten the drain hose end
on to the drain port using the metal clip included in the package.
4. If you so wish, you may connect the water inlet hose on to the
kitchen sink tap. You must obtain correct
ittings/adaptors to match the inlet hose
connectors to ensure secure connection.
However, permanent plumbing is recom-
mended.
5. If leaks are located, immediately shut the
water supply and check the hose connec-
tions fully. Tighten connections if neces-
sary.
6. If for any reason you are unable to
stop the leak yourself please seek
advice from a qualiied plumber.
7. The minimum height clearance re-
quired to install your dishwasher
on a countertop surface with over-
head cupboards is 19” (48cm).
8. Make sure there is an electrical
power supply within easy reach of the machine. The power cord is
6 feet (182.8cm) long.
9. The dishwasher must be installed on a ‘solid’ level surface.
10. To level the dishwasher, adjust the 4 level screws (feet) under the
dishwasher.
INSTALLATION INSTRUCTIONS