40
OPERATING the FIREPLACE
Element4 Gas Fireplaces
European
Home
.com
Note: The system shuts off the appliance completely if there is no change in the flame height
for 5 days.
Setting °C/24 Hour or °F/12 Hour Clock.
Press
OFF
and
È
to toggle between °F/12 hr and °C/24 hr clock.
Setting the time.
Simultaneously press the
È
and
Ç
buttons, the display will flash.
Press
Ç
to set the hour and
È
to set the minute.
Press
ON
/
OFF
to return to manual mode.
Igniting the Appliance.
NOTE:
During start-up, the
MANUAL
knob on the gas valve cannot be in the
MAN
position. It
must be in the
ON
position. (See Figure 39)
On the remote control, simultaneously press and hold the
ON
/
OFF
and
Ç
buttons.
An acoustic signal indicates that the start sequence has begun. Release the buttons.
The electronic system then checks that the main gas is flowing and ignites the main burner; this may take up to 20 seconds.
Changing the Mode of Operation.
Briefly pressing the
SET
button changes the mode of operation in the following order:
Man
-
Temp
-
Temp
-
Timer
- back to
Man
Man - Manual Flame Height Adjustment.
To increase the flame, the
Ç
button should be depressed. Pressing the
È
button on the handset will reduce the flame. The main
flame may be lowered all the way down until it is off, leaving only the pilot ignited. This is called standby mode.
Fully Extinguishing the Appliance
From any heat setting, press the
OFF
button for a few seconds. This will cause the burner to fully extinguish.
The system has a safety interlock which will not allow the ignition until the interlock rests. This may take a few minutes.
The appliance should be shut off completely using the
OFF
button on the handset and not left on pilot only, except for
temporary use. This resets the system and all safety features.
Temp - Daytime Temperature mode.
The appliance must be in standby mode, pilot ignited. The room temperature is measured and compared to the set temperature.
The flame height is then automatically adjusted to reach the daytime set temperature.
UP
DOWN
USING THE REMOTE CONTROL ELECTRONIC IGNITION SYSTEM
ON/OFF
SET
Figure 37
Receiver
RESET
BUTTON
Figure 38
Remote Control
PAIRING THE REMOTE AND RECEIVER
(for first fire and when reset is needed)
From the factory, the remote control will communicate with the receiver; they are ‘paired’ and should need no further attention. If
the receiver does not respond to commands from the remote they should be paired to each other. This is done as follows:
1. Press and hold the receiver reset button (Figure 37) using a small, long tool until you hear the second of two beeps. After the
second beep release the reset button.
2. Press and hold the
È
(down) button on the remote until you hear the second of two beeps. Release the
È
(down) button.
HOW TO LIGHT YOUR FIREPLACE
