USER MANUAL
14
FOR SUPPORT, VISIT ELEMENTELECTRONICS.COM/SUPPORT
15
MAINTENANCE AND CARE
Check your cleaner’s brush roll and drive belt regularly for wear or damage. Clean the brush and brush
ends by removing string, hair and carpet fibers. These can wrap around the brush and hamper its ability
to effectively clean your carpet. Also remove any debris that has accumulated under the brush cover.
1. Turn off vacuum and unplug from electrical outlet.
2. Place vacuum upside down with brush roll facing upwards.
3. Remove the seven screws as shown with a small Phillips screwdriver.
4. Lift off brush cover.
5. Grasp floor brush at both ends and remove by lifting out.
6. Clean string, hair and other debris from floor brush, motor pulley, and drive belt.
7. Check floor brush for worn areas and replace if needed.
8. Check air passageway for obstructions. Remove debris from this area.
9. When finished cleaning, reposition floor brush and drive belt. Turn floor brush
by hand several times in the direction of the motor pulley.
10. If properly installed, the drive belt will align itself on floor brush.
Then replace the brush cover and re-install the seven screws.
Replace Brush Roll
WARNING:
Turn off and unplug vacuum cleaner before performing
maintenance to the vacuum cleaner.
1
2
3
4
5
MAINTENANCE AND CARE
Replace Drive Belt
WARNING:
Turn off and unplug vacuum cleaner before performing
maintenance to the vacuum cleaner.
1
2
3
4
WARNING:
The plug must be removed from the power socket before any
maintenance or replacement. If the power cord is damaged, replace them
only by the factory or maintenance center or similarly qualified persons.
Remove
seven
screws
Lift off
brush
cover
Check the drive belt carefully for wear, cuts and stressed areas. If the drive belt appears worn, you will
need to replace it.
To remove the drive belt, read the instructions and follow the drawings below:
1. Use Phillips screwdriver to remove 7 screws from brushroll cover. Lift off cover.
2. Grasp the old drive belt and remove from motor shaft. Discard old drive belt.
3. Loop new drive belt over motor shaft and stretch other end over floor brush
in the space provided between the bristles.
4. Place ends of floor brush down into slots on sides as shown.
5. Turn floor brush by hand several times in the driection of the motor shaft.
If properly installed, drive belt will align itself on floor brush.
6. Replace brush cover and re-install the seven screws.
Replace brush
cover and re-install
seven screws
