Elektronik Sachse ZDG 3.23, Руководство по установке

Страница: 15 / 18

5
Connector Function
1 Ignition coil cylinder left
−
2 Ground
3 Pickup lead, brown
4 Pickup lead, green
5 Pickup lead, yellow
6 Pickup lead, white
7 Output for electronic tachometer
8 +12 supply voltage, switched
9 Ground (same as #2)
10 Ignition coil cylinder right
−
5 Settings
•
Bring the left piston into TDC position. (convergence marking B with arrow A on the
wheel). Check the TDC by watching the left piston through the spark hole.
•
Rotate the disc into the position as shown in the picture. The lower Hall sensor must be
between the two magnets (’N’ and ’S’ marking) in the disk.
•
Turn on the ignition switch, both LEDs are indicating.
•
Turn the disk slowly to the ’N’-marking until the Led is switching of. The disk is in the
correct position and can be tightened by the set screws.
•
Notice: You can’t switch the LED on only by turning back to the ’N’-marking. Therefore
the disc must be turned back to the ’S’ marked magnet.
•
Check the ignition timing with a strobe and if necessary, correct the position of the disc