Elektro-Automatik 09 230 430, Инструкция по эксплуатации

Страница: 52 / 74

52
© 2006, Elektro-Automatik GmbH & Co. KG
Irrtümer und Änderungen vorbehalten
EN
Instruction Manual
PSI 8000 3U Series
Date: 05-03-2012
• Models
from 400V
output voltage
Screw-clamp terminal, plastic
Recommendation: ring cable lugs 6mm
5.6 Grounding the output
Attention! Read carefully!
Grounding of the DC minus (-) output of single units or
multiple units in parallel is always possible. Grounding
the DC plus (+) output is only allowed for models of up to
300V nominal voltage!
Watch the potential shift of the output poles when using
series connection! Grounding is hereby only allowed for
the pole with the lowest potential against ground. Maximum
allowed voltage of a series connection: 600V DC.
Attention! When grounding one of the DC output pole take
care if the consumer, for example an electronic load, is also
grounded on one of its poles! It may become a short-circuit!
5.7 Terminal „Sense“ (Remote sense)
In order to compensate the voltage drop along the load cables,
the power supply can „sense“ the voltage at the load instead at
the output. It will regulate the output voltage so that the desired
voltage is provided to the load. For maximum regulation see
section „2.2 Device specifications“, information „Remote sense
compensation“.
The connection for remote sense is done at the terminal „Sense“
on the rear side. Also see section 3.1.
(+) Sense must only be connected to (+) at the load appli-
cation and (–) Sense must only be connected to (–)! Else
both systems can take damage.
For additional information also see section 8.7.
About the device
5.8 Terminal „Share“
In case Share bus operation is wanted, the „Share“ terminal of
the concerning units just have to be connected to each other:
Nothing more required. For details about Share bus operation
refer to section „11.1 Parallel connection in Share bus mode“.
Attention! Share bus connection with units different to
3U series, which also feature a Share bus, is not allowed!
5.9 Interface card slot
The unit can be equipped with an optional interface card. The
slot to insert the card is located at the rear side. Further infor-
mation about the interface cards can be found in section „9.
Digital interface cards“, in the separate instruction manual for
the interface cards and on the quick installation guide for the
interface cards.