elektraLite MY575w, Руководство пользователя, Страница: 5 / 24

-
４
- MY575 WASH
b) Mounting MY575w
The installation of
MY575w
has to be built and constructed in a way that it can hold 10 times the weight for 1
hour without any deformation.
The installation must always be secured with a secondary safety device (a safety cable).
Never stand directly below
MY575w
when mounting, removing or servicing
MY575w
.
The installer should make sure that
MY575w
is installed correctly and that the installation is checked by an
expert on a regular basis.
If you are a rental house utilizing
MY575w
, then use the appropriate half couplers (½ cheeseboros) to secure
the fixture to the truss or pipe. Remember to tighten down the cheeseboros before raising the truss. Don’t
laugh! It has been done before now. Remember with yoke fixtures on a flown truss, when you move them the
truss can move too. It’s just obeying Newton’s third law of motion: “to every action there is an equal and
opposite reaction”. Please remember this when securing the
MY575w
fixture.
Cautions:
MY575w
should be installed outside areas where people can reach it, walk by it or be seated underneath it
when being installed. Overhead mounting requires experience including, amongst other things, calculating the
working load limits and installation material being used. Periodic safety inspections should be done of
MY575w
as the fixture does move. If you do not have the qualifications and experience, do not attempt the installation.
Improper installation can result in bodily injury to yourself or others.
Before mounting make sure that the installation area can hold a minimum point load of 10 times
MY575w’s
weight.
Once installed then connect
MY575w
to the correct power source. 120 volts A.C.
Installation via the Omega U Brackets.
Screw one clamp (the clamp is not provided with
MY575w
) onto each of the two Omega U brackets supplied
with
MY575w.
Insert the quick-lock fasteners of the first Omega bracket into the respective holes on the bottom of
MY575w
.
Tighten the quick-lock fasteners fully clockwise. Install the second Omega U bracket. Please do not use pliers,
crest wrenches and the like to turn the quick-lock fastener. If you do, there is very real likelihood that you will
break the Omega bracket. (These can be replaced at a substantial cost to your boss!)
Pull the safety cable through the holes on the bottom of the base and over the trussing or any secondary fixing
point. Do not clamp the cable to the U bracket or clamp. That is not a secondary safety point.
A secondary safety point is any point that will adequately hold
MY575w
if the U brackets, clamps or the fixtures
base breaks or fails. Then the safety cable would be the backup and stop the fixture from falling to the ground.