Electronics Logic SP-16, Руководство пользователя

Страница: 5 / 12

- ROOM REGULATOR room regulator may be
connected to the controller.It controls CH
circulation pump. Two-core cable is led out from
room regulator that should be connected to jack
input. No external power sources should be
connected to the device during installation of
room regulator. When function is turned on, an
arrow should appear on the display (upper right
area). If room regulator is not connected to the
device this function should not be turned on.
5
END OF WORK
END OF WORK
YES
TURN OFF TIME
TURN OFF TIME
60 min
ROOM REGULATO
ON
ROOM REGULATOR
- MANUFACTURER SETTINGS controller is
equipped with programmed settings, you may
return to them at any time. However, you should
remember that all personal settings will be lost.
- END OF WORK turns the controller off. To turn
It on again press and hold ENTER button.
Controller has got hidden installation menu, to get there press and hold
( ) and ( ) buttons for 3 seconds. Changes of parameters in that menu
should be made by qualified person. Your changes of those parameters
may cause controller misoperation.
INSTALLATION MENU
- TURN OFF TIME function is to set time which is
measured when CH temperature does not
o
increase and maintains 5 C below set
temperature.
- BLOWER START-UP this function consists in
setting 100% power of blower with time
parameter (1sec. - 15 sec.) which, due to
temporary loss of efficiency, has to be regulated.
When you notice that the blower does not work
correctly during start.
SP 16 Manual
MANUF. SETTINGS
MANUF. SETTINGS
YES
BLOWER START UP
BLOWER START UP
1.0 sek.
CH 22
HSV 22 0 0 C z 55 C
0 0 C z 45 C