Electrolux WT GL3 Vi 200, Руководство пользователя

Страница: 22 / 68

4. Remove the inlet hose behind the ap-
pliance.
5. Clean the filter in the valve with a stiff
brush or a towel.
45°
20°
6. Install again the inlet hose. Make sure
that the couplings are tight to prevent
leakages.
7. Open the water tap.
EMERGENCY EMPTYING OUT
If the water is not discharged, proceed as
follows to empty out the appliance:
1. pull out the plug from the power sock-
et;
2. close the water tap;
3. if necessary, wait until the water has
cooled down;
4. place a bowl on the floor;
5. place the end of the emergency empty-
ing hose into the bowl;
6. Remove its cap. The water should drain
by gravity into the bowl. When the bowl
is full, put the cap back on the hose.
Empty the bowl;
Repeat the procedure until water stops
flowing out;
7. clean the pump if necessary as previ-
ously described;
8. replace the emergency emptying hose
in its seat after having plugged it;
9. screw the pump again.
FROST PRECAUTIONS
If the machine is installed in a place where
the temperature could drop below 0°C,
proceed as follows:
1. close the water tap;
2. unscrew the water inlet hose from the
tap;
3. place the end of the emergency empty-
ing hose and that of the inlet hose in a
bowl placed on the floor. Let water
drain out;
4. screw the water inlet hose back on;
5. put the cap on the emergency empty-
ing hose again;
6. reposition the emergency emptying
hose.
By doing this, any water remaining in the
machine is removed, avoiding ice forming
and consequently damage to the appliance.
When you use the machine again, make
sure that the ambient temperature is above
0°C.
TROUBLESHOOTING
Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engi- neer. Before contacting your local Service
Centre, please carry out the checks listed
below.
22 electrolux