Electrolux SPEEDELIGHT, Оригинальное руководство пользователя

Страница: 21 / 38

21
electrical cable sheathing, etc.) the operator for normal
machine use must:
• immediately deactivate the machine.
II O OP PE ER RA AT TIIN NG G
II..1 1 S Stta arrtt u up p
W WA AR RN NIIN NG G
Refer to “
Safety Information
“.
Press the ON/OFF button to switch on the appliance.
The display shows first the “Welcome“ screen, the lid opens
automatically and then the preheating starts.
During this time, up to 20 minutes, the appliance will not be
operational.
At the end of the preheating mode the display will show all the
programs available and the appliance is now ready to use.
II..2 2 S Se ett a a p prro og grra am m
To start the required program, close the lid and press the
corresponding program button.
NOTE!
In the case of the keyboard with the 3/4 and S
buttons, the button 3/4 corresponds to the number 3
program while S is the number 4, in the setting of
programs.
The dash in place of the program number means
that this program was deleted.
To set up a program enter a time for the cycle.
To delete a program, you must reset the time of the
cycle.
The display shows the following information when the cycle
starts.
A. Program number.
B. Program remaining time.
C. Microwave phase is on.
D. To interrupt the cycle press the buttons 7 or 8 within 9
seconds.
NOTE!
If you open the lid before the end of the program,
the display shows this icon and an acoustic
signal sounds for 5 seconds. When the acoustic
signal stops to sound, the icon is on, at bottom of
the display. To remove it you must access into the
advanced menu pressing simultaneously the but-
tons 7 and 8 for 4 seconds and entering the
password.
When the display shows the following icon (yellow triangle)
switch off the appliances and after switch on.
If the same icon shows again on the display pressing
simultaneously the buttons 1 and 2 for 4 seconds and you
communicate the indicated error to the Service.
( Welcome )