Electrolux EWF1110, Руководство пользователя

Страница: 13 / 26

electrolux front loading washing machine operating sequence 9
12. At the end of the program.
The appliance stops automatically. The display and all
the pilot lights go off. The drum lamp lights up and the
door can be opened.
At the end of a program with RINSE HOLD option, the
door is locked to indicate that there is water in the tub.
To empty out the water follow the following instructions:
• turn the program selector dial to SPIN ONLY program;
• reduce the spin speed if needed, by means of the
Spin Speed button;
• press the Start/Pause button;
• at the end of program, the display and all the pilot
lights go off and it will be possible to open the door, or
• turn the program selector dial to SPIN ONLY program,
select the NO SPIN option and then press the Start/
Pause button: the water is just drained without
spinning.
Remove the laundry from the drum and carefully check
if the drum is empty.
If you do not intend to carry out another wash, close the
water tap.
warning
DO NOT leave the door open. An open door could
entice children to hang on the door or crawl inside the
drum.
NOTE: If there are no small children present, leave the door
open to prevent the formation of mildew and unpleasant smells.
8. Start the program by pressing Start/Pause button.
To start the selected program, press this button. The
DOOR LOCK pilot light will light up and the actual
program phase pilot remains lit to indicate that the
appliance is operating and the door is locked.
The appliance will not operate with the door open. The
program phase lights will blink,the acoustic signal will
beep and
will be displayed as a reminder to close
the door.
9. Altering an option of a running program
It is possible to change some options before the
program carries it out.
Before you make any change, you must pause the
washing appliance by pressing the Start/Pause button.
To carry on the program, press the Start/Pause button
again.
The BUZZ VOLUME can be changed at any time.
10. Cancelling or changing a running program
Press the Cancel/Reset button to cancel a program
which is running. The appliance is now switched off.
To switch it on again, just press any button or turn the
program selector dial.
The appliance will show the last selected program. Now
you can select a new program. The washing water in
the tub will not empty out. It’s not possible to change a
running program without cancelling it and then setting a
new program.
11. Interrupting a program and opening the door after
the program has started.
If you wish to add a forgotten item to the wash drum,
first set the appliance to pause by pressing the
Start/Pause button. The message
is displayed
alternately with the estimated program time.
If the pilot light DOOR LOCK starts blinking, after a few
minutes it will go off and the door can be opened. If it
does not switch off, this means that the appliance is
already heating, that the water level is above the bottom
edge of the door. In this case, the door cannot be
opened.
If you cannot open the door but you need to open it,
you have to switch the appliance off by pressing the
Cancel/Reset button. In case of high water level and
temperature, you must first empty out the water and
then open the door (please read the next step “At the
end of the program”). If the appliance is spinning, once
you set it to pause, the door can be opened after some
minutes. After closing the door, it is necessary to select
the program again and press the Start/Pause button.