Electrolux EWF 14112, Руководство пользователя

Страница: 17 / 100

ENGLISH 17
When the program is completed
and the door lock indicator ‘ ’
goes off, you can open the door.
While a program or the Delay Start is
operating, the appliance door is locked
and the display shows the indicator ‘ ’.
First set the machine to PAUSE by
pressing the “Start/Pause” touchpad.
Wait until the door lock indicator ‘ ’
goes off, then the door can be opened.
If the door lock indicator ‘ ’ does not
disappear, this means that the machine
is already heating and the water level is
above the bottom edge of the door or
the drum is turning. In this case the door
CAN NOT be opened.
If you can not open the door
but you
need to open it you have to switch the
machine off by pressing the ‘On/Off’
button to deactivate the appliance. After
about 5 minutes the door can be
opened.
CAUTION: Pay attention to the
water level and water
temperature.
1.
3.
2.
When The Washing Program
Is Completed, But There Is
Water In The Drum
The drum turns regularly to
prevent the creases in the
laundry.
You must drain the water to open
the door.
The door lock indicator ‘ ’ is
on. The door stays locked.
To drain the water:
Press the touchpad Start/Pause.
The appliance will drain the
water and spin.
If necessary, decrease the spin
speed.
Set the “Spin” program.
4.
Press the ‘On/Off’ button to
deactivate the appliance. 5.
-
-
5.5 Opening The Door
5.7
The appliance stops automatically.
The acoustic signal will operate.
The display will show ‘ ’.
The indicator of the touchpad
Start/Pause goes off.
-
-
-
-
-
-
-
-
The door lock indicator ‘ ’
goes off.
Remove the laundry from the
appliance. Make sure that the drum is
empty.
Keep the door ajar, to prevent the
mildew and odours.
Turn off the water tap.
5.6 At The End Of The Program
Press the touchpad Start/Pause.
The indicator will start flashing. 1.
Change the options. 2.
Press Start/Pause again. The
program will continue. 3.
At the end of the program the
time remaining can suddenly
decrease from 7 minutes or less
to 0 due to the overestimated
total program time during the
load sensing phase. In some
cases (with perfectly balanced
load) the program time can be
shorter than the time estimated
after the load sensing phase is
completed. This is a normal
behavior of the machine and not
a cause for concern as it does
not compromise its performance.
AUTO Stand-by Function 5.8
The AUTO Stand-by function
automatically deactivates the
appliance to decrease the energy
consumption when: