Electrolux ESI6180U, Руководство пользователя

Страница: 26 / 28

Page
26
DW 107
Setting the Test Cycle
With the door CLOSED and the dishwasher switched OFF
1
. Press and hold down
Sw2
&
Sw5
.
2
. Press
Sw0
to switch the appliance on.
3
. Hold down
Sw2
&
Sw5
for about
5 seconds
until the buzzer sounds.
After 5 seconds, the display will show [
C O L
] (abbreviation for “collaudo” = test) & [
P 1 3
]
alternately to show the status of the test cycle.
4
. Press
Sw5
to start the cycle
The display will show [
C 0 L
] for the entire duration of the cycle.
During the Cycle:
If the door is opened, the diagnostics cycle is interrupted but not cancelled.
If the dishwasher is switched off by pressing
Sw0
, or in case of a power failure, the diagnostics
routine is interrupted, but not cancelled; when the dishwasher is switched on again, the cycle
resumes normally from the point at which it was interrupted.
To cancel the diagnostics cycle currently being performed, press
Sw5
and hold down for
5
seconds
.
At the end of the cycle, the display shows [
- - -
] (three central segments) to indicate the end of
the programme and the appliance exits the test procedure automatically.
After a further
5 seconds
, the display shows the last programme performed (before the test
cycle), e.g. [
P . 3
].
Press
Sw0
to switch the appliance off.
NOTE:-
The safety devices are operative during the diagnostics cycle; in case of a malfunction, the
relative ALARM code is shown in the DISPLAY.