Electrolux ESI6180U, Руководство пользователя

Страница: 24 / 28

Page
24
DW 107
INDICATIONS
Once the Diagnostics cycle has started, the sub-phase can be advanced according to the sequence of the
washing cycle selected, simply by pressing a key.
The Display (…) shows the current sub-phase via the 3 digits:-
DGT_1 & DGT_2 [
F
] [
d
] Two letters (Abbreviation for Function Diagnostics)
DGT_3 [
.
] Number of Sub-phase currently being performed
[ 0, 1, 2, 3,
or
4 ]
Example: [
F d 1
] Water drain
FUNCTION DIAGNOSTICS PROCEDURE
Any washing programme can be selected for the diagnostics cycle.
Select a programme which includes the PRE-WASH + WASH + RINSE + DRYING phases; these
utilize all the sub-phases to be checked.
In order to test the regeneration function, it is necessary, before entering the diagnostic cycle, to
ensure that regeneration is set to a level in which regeneration is performed during every cycle
(e.g. [
L . 7] [L . 8] [L . 9]
).
Selecting and Executing the Cycle
With the door CLOSED and the dishwasher switched OFF (Programme selection mode):
1.
Press and hold down
Sw2
.
2.
Press
Sw0
to switch the appliance on.
3.
Hold down
Sw2
for about
5
seconds, after which the buzzer will sound.
The 3 digits on the display will alternately indicate the last programme performed and two letters
(abbreviation for Function Diagnostics) - e.g. [
P . 3
] [
F d .
].
4.
Press
Sw1
to select the desired cycle.
5.
Press
Sw5
to start the cycle.
The 3 digits on the display will indicate [
F d 1
] in which (
1
) indicates the number of the current sub-
phase (as each cycle begins with a water drain sub-phase).
6.
Press
Sw2
to pass to the next sub-phase and so on until the end of the cycle.
Continue to press
Sw2
until the desired sub-phase is reached for the cycle entered (the sequence is
shown in the programme table on P23).
If
Sw2
is not pressed, the cycle proceeds normally.
Passage from one sub-phase to the next is shown on the display, which indicates the number of the
sub-phase being performed (example: [
F d 0
] - water fill)
If the door is opened, the diagnostics cycle is interrupted, but not cancelled; when the door is closed
again, the cycle resumes from the same position.
If the dishwasher is switched off by pressing
Sw0
, or in case of a power failure, the diagnostics
routine is interrupted; when the dishwasher is switched on again, the cycle resumes normally from the
point at which it was interrupted