24
Feet Assembly
Before installing the cooker, it is necessary to
assemble the supplied feet.
1.
Remove the hob pan supports, the burner caps and
crowns and the oven accessories.
2.
Carefully lean the cooker on its back, paying attention
not to cause any damage.
3.
Adjust the feet height by unscrewing the bottom part
of each foot, until you obtain the required height (height
can be adjusted from 850 to 880 mm).
4.
Insert the feet into the relevant holes indicated in the
diagram.
5.
Lift the cooker in vertical position. Replace the crowns,
the burner caps, the hob pan supports and the oven
accessories.
6.
If necessary, adjust the cooker horizontally levelling
by turning the bottom part of the feet, until the
appliance is completely stable.
This appliance cannot be positioned on a
base.
The following instructions are meant for a qualified
installer, in order that the operations of installation,
regulation, and service are executed according to the
existing regulations.
Before using the unit, take off the special protective layer
which protects the stainless steel and anodyzed tin
parts. Whenever changes are mode involving the
disconnection of the machine it is necessary to proceed
with maximum caution.
THE MANUFACTURING COMPANY DECLINES
ANY RESPONSABILITY FOR POSSIBLE
DAMAGES RESULTING FROM AN
INSTALLATION WHICH DOES NOT COMPLY
WITH THE RULES IN FORCE.
Installation environnement
Warning
- This unit can be installed and can work only
in constantly ventilated rooms, according to rules in
force.
In order to make the gas unit work properly, it is
necessary that air sufficient to gas combustion can
naturally flow in the room. (The installer must follow the
rules in force).
The air flow into the room must come directly through
openings of external walls. These openings (or opening)
should be made in such a way not to be occluded both
from inside and outside.
Installation and maintenance must be carried out by a
qualified technician, in compliance with the rules in force.
The electric coonection must be carried out in
compliance rules in force.
Our responsability will not be involved in case of
accidents caused by a defective or non existent
earth connection.
Combustion products discharge
Gas cooking units must discharge combustion products
through hoods directly connected to flues or outside.
Installation
Positioning
This appliance has been designed to be placed close to
furniture units not exceeding the height of the working
level.
Insertion possibility
In case of insertion of the appliance between kitchen
units, the dimensions to be respected are shown in the
picture.
When the kitchen is installed according to class 2, sub-
class 1 (i.e. built-in) for the gas connection use only
flexible metallic tubes conforming to rules in force.
100
500
650
FO 1076
