Electrolux EHG313BA, Руководство пользователя

Страница: 11 / 34

11
Ifyouhaveaproblemwiththecooktop,checkthetable
below. You may be able to solve the problem and this
will save you from paying for a service call. You will have
to pay for a service call even in the warranty period if the
problem is one listed below.
trouBLESHootInG
Table 1
problem possible cause solution
Burner will not light
even though the
sparker is working • Knob not held down long enough in ‘HIGH’
position for flame safeguard.
• Gas supply valve turned off.
• Wrong knob turned.
• port blockage in ignition area.
• Ignition spark plugs wet or dirty.
• repeat lighting procedure and hold knob
down for 5 seconds in ‘HIGH’ position.
(refer page 8).
• turn on gas supply to appliance.
• Ensure the knob you are turning corresponds
to the burner you want to light.
• Ensure that ports in ignition area are clean
and dry.
• Dry or clean ignition spark plugs.
no spark is
obtained when
control knob is
activated • Electricity supply is disconnected or switched
off.
• Ignition spark plugs wet or dirty.
• Switch on electricity or check fuses.
• Dry or clean ignition spark plugs.
flames uneven or
tending to lift • flame ports blocked or wet.
• Burnercapincorrectlyfitted.
• Clean or dry flame ports.
• Ensurethiscomponentisfittedcorrectly.
flames not staying
on when knob is
released • Knob not held down long enough in ‘HIGH’
position for flame safeguard
to engage.
• Knob not set between ‘HIGH’
and ‘LoW’
• Dirt or spillage on flame
safeguard sensor.
• repeat lighting procedure and hold knob
down for 5 seconds in ‘HIGH’ position.
(refer page 8).
• Knob muSt be set between
these positions.
• Clean flame safeguard sensor tip.
Lowheat,
slow cooking • Incorrect cooking pot or pan being used. • refer to figure 5 (page 9).
Benchtop or knobs
overheating • Incorrect cooking pot or pan used.
• pot or pan not located on burner properly. • refer to figure 5 (page 9).
• Ensure pot or pan is centrally located on
burner.
Cooktop stainless
steel discloloured • pot or pan being used is too large. • Ensure pot sizes used are as per user
manual requirements. Clean with StEEL
poWEr (available through spare parts).
outer ring of wok
burner goes out
when set to low • this is not a failure. this is a function of the
dual wok burner to give a very low power
flame option.
• no remedy - burner is functioning
as intended.