Electrolux EHD68210P, Руководство пользователя

Страница: 14 / 20

Installation instructions
Safety instructions
Warning! This must be read!
The laws, ordinances, directives and stand-
ards in force in the country of use are to be
followed (safety regulations, proper recycling
in accordance with the regulations, etc.)
Installation may only be carried out by a quali-
fied electrician. The minimum distances to
other appliances and units are to be ob-
served.
Anti-shock protection must be provided by
the installation, for example drawers may on-
ly be installed with a protective floor directly
underneath the appliance. The cut surfaces
of the worktop are to be protected against
moisture using a suitable sealant.
The sealant seals the appliance to the work
top with no gap. When building in, protect the
underside of the appliance from steam and
moisture, e.g. from a dishwasher or oven.
Avoid installing the appliance next to doors
and under windows. Otherwise hot cook-
ware may be knocked off the rings when
doors and windows are opened.
Warning! Risk of injury from electrical
current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of volt-
age.
• Follow connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection by installing
correctly.
• The appliance must be connected to the
electrical supply by a qualified electrician.
• Loose and inappropriate plug and socket
connections can make the terminal over-
heat.
• Have the clamping connections correctly
installed by a qualified electrician.
The connection must be carried out as
shown in the diagram, refer to the sticker
on the back of the hob for wiring connec-
tion diagram. The connection links should
be fitted according the appropriate con-
nection diagram. Note for single phase
connection, the link (or bridge) will need to
be fitted between terminals 1 and 2 (refer
to the connection sticker on back of the
unit). The earth lead is connected to ter-
minal
.
The earth lead must be longer than leads
carrying electric current.
• Use strain relief clamp on cable.
• In the event of single-phase or two-phase
connection, the appropriate mains cable
of type H05BB-F Tmax 90°C (or higher)
must be used.
• If this appliance’s mains cable is damaged,
it must be replaced by a special cable (type
H05BB-F Tmax 90°C; or higher). Please
contact your local Service Force Center for
further advice.
A device must be provided in the electrical
installation which allows the appliance to be
disconnected from the mains at all poles with
a contact opening width of at least 3 mm
Suitable isolation devices include line pro-
tecting cut-outs, fuses (screw type fuses are
to be removed from the holder), earth leak-
age trips and contactors.
Sticking on the seal
• Clean the worktop in the area of the cut-
out section.
• Stick the one-sided self-adhesive sealing
tape supplied all the way round the lower
edge of the cooking surface along the out-
er edge of the glass ceramic panel. Do not
stretch it. The cut ends should lie in the
middle of one side. When you have cut it
to length (add a few mm), press the two
ends flush up against one another.
A duplicate rating label is supplied with this
unit. For easy identification of this unit after
installation, stick it to a readily available sur-
face adjacent to the cooktop.
Caution! The surface temperature
exceeds 95°C. To avoid a hazard, under
bench access must be restricted.
14 electrolux