The slot-in type installation uses the appliance as supplied.
The appliance can be mounted on a plinth. This enables
a continuous cupboard kickboard to be installed, giving
a more integrated appearance. There is no clearance
requirement between oven and adjacent side cabinets.
600mm minimum
vertical clearance
from combustible
surfaces
This surface to be level with the
top edge of the kick board
755mm
900mm
900mm
minimum
600mm
• The anti-tilt brackets are to be secured to the back wall
with appropriate fasteners.
• Two stops are to be screwed to the plinth in locations
as shown (stops provided). The stops locate into slots in
the base of the appliance to prevent the product from
being pulled forward when installed.
• Measurements from the rear wall are to be adjusted if
there are tiles etc. that come between the appliance
and the wall.
• Once services are connected, product can be lifted
onto the plinth and pushed back carefully, ensuring the
appliance engages into both brackets at the rear and
the front stops.
• If the product requires removal for service, it must be
lifted at the front approximately 5mm to clear the front
stops prior to being pulled forward.
+
+
+
+
+
+
CL
+
+
+
+
104
104
370
370
165
165
344
344
Location of holes for front stops
Measurements are to be adjusted to account for the thickness
of any skirting board or tiles coming between the back of the
appliance and the wall
Front stops
Front stops
4
Slot-in installation
Installation guide
90cm freestanding cookers
