Levelling oven
Place a level in the oven as below making sure the level sits on the front
and rear forms. Adjust the feet accordingly to level the appliance.
Installing splashback
Fit splashback to rear of hob with three screws provided.
Installation of anti-tilt bracket
To ensure cooker stability, the anti-tilt brackets must be installed.
There are left and right engagement slots for the anti-tilt bracket at the
bottom rear of the appliance. The following steps must be followed to
ensure the correct installation of anti-tilt brackets and the stability of the
appliance.
Anti-tilt
brack
et engagement
slots
CAUTION
It is not recommended to push and pull the appliance on uneven
or rough surface. Use other means to manoeuvre the appliance if
necessary.
1. Carefully push the appliance into the cabinet cavity until the back of
the oven is flush against the back wall.
2. Use non-permanent methods to mark a line on the wall along the
top surface of the splashback. This line is used as a reference line to
locate the correct location of where the anti-tilt brackets need to be
installed.
3. After the reference line is marked, pull the appliance out of the
cabinet cavity to install the anti-tilt brackets.
Anti-tilt bracket installation
reference line
WARNING
• Appropriate fasteners must be used to suit the type of wall on which
the anti-tilt brackets are installed.
• Freestanding unit must be pushed up against the wall on installation.
On gas units check that the gas hose, if used,
has not been kinked during installation.
4. The anti-tilt brackets must be secured to the rear wall of the cavity
with appropriate fasteners according to dimensions in diagram.
Install anti-
tilt brackets
in this
orientation
as shown
(fasteners not
supplied)
C
L
425
Anti-tilt bracket installation
reference line
72
5
370
370
Freestanding installation checklist
Connect services to the appliance prior to placing into cavity.
To locate appliance, slide into cavity ensuring the anti-tilt brackets fully
engaged with the rear left and right engagement slots.
The unit must be pushed against the wall on installation.
Re-install oven door, burner body, burner caps and trivets after the
appliance is placed in the cavity.
Gas only: check that the gas hose, if used, has not been kinked during
installation
3