MAINTENANCE AND CLEANING
CAUTION!
Before maintenance or cleaning is carried out,
the rangehood should be disconnected from
the main power supply. Ensure that the rangehood
is switched off at the wall socket and the plug
removed if fitted.
External surface are susceptible to scratches
and abrasions, so please follow the cleaning
instructions to ensure the best possible result
is achieved without damage.
These instructions must be followed to avoid a
fire risk.
Stainless steel surface
Clean stainless steel surface using non-abrasive cleaning
products that specifically for use on stainless steel. To
ensure best results also use an even pressure and follow
the grain of the stainless steel. Use of a soft cloth reduces
the risk of scratching. If the cloth is wet ensure that a dry
soft cloth is used to wipe down the surface again reducing
the risk of any surface rust appearing.
Control panel surface
The control panel can be cleaned using warm soapy
water. Ensure the cloth is well wrung before cleaning.
Use a dry soft cloth to remove any excess moisture
left after cleaning.
Removing the metal grease filters
Push the grease filter towards the left side of the unit and
then pull it down.
The mesh filters can be cleaned by hand in warm soapy
water. Soak in warm water and some washing up liquid.
For stubborn grease stains use a soft nylon brush to help
remove these stains. After cleaning ensure that the filters
are completely dry before refitting.
Hand washing
To fit the filter, lock it until stop click is heard
Pulling out each latch, tilt the filter down and remove
This filter cannot be cleaned or re-used and as a
general rule, the activated charcoal filter should be
changed one every 2 months.
The charcoal filter should only be used if you want
to use the cooker hood in the recirculating mode.
Charcoal filter
Changing the lamps
Lamps are long life LED lamps and should not require
service. If there is an issue with lamp please contact
the Service Center, Service contact details shown on
page 12.
Place grease filters in the dishwasher. Select the most
powerful washing grogram and highest temperature, at
least 65.
Refit the grease filters when they are dry. When washing the
metal grease filter
in the dishwasher a slight discolouration of
the filter can
be occur, this does not have any impact on its
performance.
10
12
TROUBLESHOOTING
Problem
Remedy
The cooker hood will not start Check that the hood is connected to an electrical supply
Check that a fan speed has been selected
The Rangehood is not working Check that the fan speed is set high enough for the task
The grease filters are clean
The kitchen is adequately vented to allow the entry of fresh air
If set up for recirculation, check that the charcoal filter is still effective
If set up for extraction, check that the duct and outlets are not blocked
Do not operate cooktop without pots/pans
Do not flambe under cooktop
The rangehood has switched
off during operation
The safety cut-out device has been tripped-turn off the hob and wait for the device
to reset. If the hood has been installed below the heights indicated in the installation
instructions the motor will cut out frequently which will damage the hood
If you have completed all the above checks and are still
experiencing difficulty, please contact your local Electrolux
Service Centre.
Note: This product is fitted with a safety cutout device.
If the rangehood is installed too close to the cooker top,
flambe cooking, operating the cooktop without cooking
utensils and blocked filters may activate the safety
cutout device. If the hood stops during operation,
correct the faults and allow time for the safety cutout
device to
reset. Then the rangehood will function
correctly.
Do not operate cooktop without pots/pans
Do not flambe under cooktop
11
Содержание EFC635SAR
Страница 7: ...12 13 ...
Страница 13: ...24 25 ...
