53
3
4
4
4
4
4
4
6
6
7
7
7
7
8
8
2a
2
2a
5
7
9
10
10
10 10
11
11
14,5
273
273
244
214
190
6
12
2
B
Fig. 9
Adjust extension of the hood support structure,
as the final height of the hood depends on this,
and remember that with installation completed
the hood must be at least 60 cm above the hob
top for electric cookers and 75 cm for gas or
mixed fuel cookers.
Fix the two sections of the structure using 8
screws (2).
Place the ceiling hole diagram directly above the
hob top (3 - the centre of the diagram must
match the centre of the hob top and the edges
must be parallel to the sides of the hob top the
side of the diagram with the wording FRONT
corresponds to the control panel
side). Prepare the electrical
connection.
Drill as shown (6 holes for 6 wall
plugs 4 plugs for fixture), screw
the outer screws leaving a space of
about 1 cm. between the screw
head and the ceiling (4).
Fit an exhaust pipe inside the
support (5) and connect it to the
motor compartment connection ring
(exhaust pipe and fixing brackets
are not supplied).
Hook the frame onto the 4 screws (6 - see also
step 4).
CAUTION! The side of the support with
connection box corresponds to the side of the
control panel with hood assembled.
Tighten the 4 screws (7).
Insert and tighten another 2 screws in the
remaining free holes (8) for secure fixing.
Carry out the electrical connection (9) to the
mains power supply, only turn on the power
supply upon completion of assembly.
Hook the hood onto the support (10) , ensuring it
fits properly to hook the hood onto the support
partially tighten 4 screws (see also step 12).
Secure the hood to the support using 6 screws
(11); this will also help centre the two sections.
Tighten the 4 screws securing the support to the
hood (12).
