Electrolux Dito TR260, Инструкция по эксплуатации

Страница: 11 / 13

Cleaning, hygiene and storage
4.
1
IN BETWEEN USE
- Open the cover and remove the cutting equipment (disc, grid,
ejector, see § 3.3) so that it may be washed in hot water.
- Wash the cutting chamber using a clean, damp sponge, paying
special attention to the grid supports, the outlet chute and the
inside of the hoppers.
ATTENTION !!
Before dismantling any part, disconnect the appliance from the power supply.
Before using any cleaning product, be sure to read the instruction and safety instructions accompanying the product and use
appropriate protective equipment.
Do not clean the machine with a pressure cleaner
4.
3
4.
2C
4.
2
AFTER USE
1) for the lever-operated hopper, remove the feed tray (see § 3.3)
and release the press lever from its swivel pin (see § 3.7).
2) for the automatic hopper, remove the press lever and withdraw
the cutting equipment.
3) In all cases, release the lid from the body by pulling pin A and
unlock the lid and raise it.
Tip: Before cleaning grids, push any cubes that are stuck with
a carrot. Do not use metallic objects.
- Clean the removable elements in a dish of water or in a dis-
hwasher using hot water and detergent/degreaser/disinfectant
compatible with the equipment.
- Rinse with clean water and leave to dry.
- Wash the cutting chamber using a damp sponge and a de-
tergent - disinfectant then rinse.
- If necessary, clean the outside of the machine and its table
using a damp sponge and a mild detergent, then rinse using
a damp sponge.
Tips: Do not use abrasive detergents which scratch the surfaces,
or chlorine based products which dull the aluminium.
- Do not clean the plastic parts in a dishwasher
4.
3
STORAGE
• After cleaning, carefully store each item of the cutting equip-
ment in the storage rack, which can hold 6 discs or grids. This
may be fi xed:
- On the shelf of the mobile table.
- On the wall using two brackets (access height of 1.80 m
max.).
Fault fi nding
5.
1
THE MACHINE WILL NOT START, CHECK THAT:
• The machine is plugged in.
• The electrical power supply to the socket is correct.
• The cover is closed.
• The feed arm is in the feed hopper.
• If the machine stops whilst in the middle of an operation:
- the thermal relay has been tripped. It will reset itself automa-
tically.
- wait for a few minutes before restarting.
- press the START button B and if necessary, reduce the force
applied to the feed arm.
5.
2
ABNORMAL NOISES
• Stop the machine immediately.
• Check that the disc, grid and ejector are fi tted correctly (the
grid may be rubbing against the grid).
• Dismantle, clean if necessary and check there are no foreign
bodies and refi t correctly.
• If the noise continues and the machine lacks power, check
that:
- the triple phase motor is not operating on double phase
- the belt is not worn or needs to be tensioned (see §6.1)
5.
3
BLOCKAGE OF A DISC
- Unplug the machine.
- Place one hand fl at on the ejector and prevent it from tur-
ning.
- With your other hand, hold the outside of the disc in the fi ngers
holes and turn sharply anti-clockwise .
- Lift it whilst turning backwards and forwards.
TR260 GB 10 07
6