Electrolux BEVERAGE CENTER II, Руководство по обслуживанию

Страница: 8 / 77

7
INSTALLATION
This Service Manual provides specific operating instructions for your
model. The customer should use this beverage center only as
instructed in the Use & Care Manual.
Before starting this beverage
center, follow these important first steps.
LOCATION
• Choose a place that is near a grounded electrical outlet.
Do Not use an extension cord or an adapter plug.
• If possible, place this beverage center out of direct
sunlight and away from the range, dishwasher or other
heat sources.
• This beverage center must be installed on a floor that is
level and strong enough to support a fully loaded
beverage center.
• Consider water supply availability for models equipped
with an automatic ice maker.
LEVELING
All four corners of the beverage center must rest firmly on a solid
floor. The beverage center is equipped with adjustable leveling screws
to help level your unit.
Raise
Stationary Front Roller
with Leveling Screw
CAUTION CAUTION CAUTION CAUTION CAUTION
• Do Not install the beverage center where the
temperature will drop below 55°F (13°C) or rise above
110°F (43°C). The compressor will not be able to
maintain proper temperatures inside the beverage
center.
• DO NOT block the toe grille on the lower front of your
beverage center. Sufficient air circulation is essential
for the proper operation of your beverage center.
• THIS BEVERAGE CENTER IS NOT INTENDED FOR
OUTDOOR USE.
INSTALLATION
Installation Clearances
• Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
Sides & Top 3/8”
Back 1”
DOOR OPENING
NOTE NOTE NOTE NOTE NOTE
If the beverage center is placed with the door hinge side against a
wall, you may have to allow additional space so the door can be
opened wider.
The beverage center should be positioned to allow easy access to a
counter when removing food. To make this possible, the direction in
which the doors open can be reversed. See
Door Removal & Reversal
Instructions.
NOTE NOTE NOTE NOTE NOTE
Raise the front of the beverage center enough so the doors
close freely when opened halfway. The beverage center
should slope ¼” to ½” from front to back. Then level the
beverage center from side to side.
To Level Your
Beverage Center:
1. Remove toe grille.
2. Use adjustable wrench to adjust leveling screws.
CA CA CA CA CAUTION UTION UTION UTION UTION
DO NOT ATTEMPT TO MOVE OR RELOCATE
THE BEVERAGE CENTER WITH A KEG
INSIDE. THE TWO FRONT LEVELING
SCREWS MUST BE RAISED BEFORE YOU
MOVE THE REFRIGERATOR TO PREVENT
FLOOR DAMAGE.