Electrolux BEVERAGE CENTER II, Руководство по обслуживанию

Страница: 14 / 77

1 3
BRAIDED HOSE TO COUPLER CONNECTION
• Slip one Worm Clamp (14) onto the other end of the braided
hose (13).
• Push the other end of the braided hose (13) onto the keg
coupler (11) until seated against hex head.
• Secure the hose (13) to the keg coupler (11) using the
remaining worm clamp (14). Use a flat tip screwdriver to
tightly secure the worm clamp to the braided hose to prevent
gas leakage.
FIRST STEPS (continued)
COUPLER TO KEG INSTALLATION
• Align locks on keg coupler (11) with housing on top of keg
and push down on the keg coupler (11).
• Turn the tap head handle clockwise 1/4 turn. The tap head is
now secured to the keg.
• Pull the tap handle out and push down to open the port in
the keg.
NOTE NOTE
NOTE NOTE
NOTE
Depending on the customers choice of beer, they may
require a different Keg Coupler (11). The customer will
need to check with there local beer distributor to determine
which type system they need, and order additional Keg
Couplers if needed. For assistance the customer can call
Electrolux Consumer Services at 1-800-944-9044
.
CLEAR HOSE TO COUPLER CONNECTION
• Place one of the supplied rubber washer (15) inside the
hex nut on the one end of the clear hose (12) (beverage
delivery line) and attach to keg coupler (11). Be sure to
tighten the nut securely to prevent leakage.
DO NOT over
tighten. Over tightening may damage the gasket in the nut.
CLEAR HOSE TO DOOR PANEL CONNECTION
• Place the other supplied rubber washer (15) inside the
hex nut on the other end of the clear hose (12) (beverage
delivery line) and attach to the Faucet & Shank Assembly
(6) protruding through the door panel. Be sure to tighten
the nut securely to prevent leakage.
DO NOT over tighten.
Over tightening may damage the gasket in the nut.
BRAIDED HOSE TO REGULATOR CONNECTION
• Slip one Worm Clamp (14) onto braided hose (13).
• Attach that end of the braided hose (13) to the hose barb of
the CO
2
regulator (10). Push hose up until seated against
hex head.
• Secure the braided hose (13) to the CO
2
regulator (10) using
the worm clamp (14). Use a flat tip screwdriver to tightly
secure the worm clamp.