20
10. Remove the 2 screws and remove the service panel.
11. Remove the two (2) styrofoam blocks located
under the drum (a yellow ribbon surrounds the items
to be removed). Lift up on the drum, tilt the base of
the foam blocks inwards toward the rear of the
washer until free, then pull them out.
12. Remove and discard the yellow ribbon from the front
of the washer.
13. Replace the service panel and screws.
NOTE:
If the washer is to be transported at a later
date, the shipping support hardware must
be reinstalled to prevent shipping damage.
Drain Hose Installation
The drain hose is field installed to allow hose orientation
to the left or right, up or down depending on location of
the house drain. The hose is shipped in the washer tub
with the spring clamp on the coupler elbow and drain
hose hanger installed on the end of the hose.
1. Remove the drain hose from the tub of the washer.
2. Push the hose onto the drain coupler at the upper
left of the washer back panel until the hose contacts
the STOP RIB.
PUSH HOSE
INTO COUPLER
TO STOP
STOP RIB
DRAIN HOSE TAB
SPRING
CLAMP
PROVIDED
ON HOSE
REMOVE LEFT
AND RIGHT
FOAM BLOCKS
TWO SCREWS
UNDER PANEL
3. Using pliers, squeeze the ears of the spring clamp
and position the clamp so the clamp ears align with
and contact the tabs on the drain hose. This assures
proper location of the clamp to prevent leaks.
ALIGN SPRING
CLAMP EARS WITH
TABS ON HOSE
