Electrolux Air-O-Chill 10GN1/1, Инструкция по установке и эксплуатации

Страница: 29 / 34

5958 992 00
EN
29
After entering a RECIPE with the AUTOMATIC or MANUAL
control (with one or more cooking phases) proceed as follows:
1) press the button P3 ( ) to enter the program memory
screen
2) Select the number to be assigned to the recipe (or program)
with knob
K .
3) First, press the button P3 ( ) to store the number with the
recipe ( without name )
P1 P3
and then the button P2 ( ) to confirm or P3 ( ) to cancel, or if a
name is to be given to the recipe ( with name ) skip this point and
go to the next.
P2 P3
4) Press the button P1 ( ) to write the recipe name
5) Turn knob K to select the first letter (or digit) of the required
name from those available in the boxes, press P2 (OK) for this to
appear in the list field. Repeat the operation for the next letters
(or digits) until the complete name has been written.
To change a letter press the button
P3 ( ) or P4 ( ) until the
required letter is selected and repeat point 5); to cancel the let-
ter insert a space
).
P1 P2 P3 P4
6) Press the button P1 ( ) to store the name of the program.
7) Press the button P3 ( ) to save the program
P3
and then P2 ( ) to confirm
P2
To repeat the same cycle with several PHASES just press the
START/STOP button again.
- SKIP PHASE -
During cooking it is possible to skip one or more phases and go
to the NEXT as indicated below:
- Press the button
P2 ( ) to select the PHASES field
- Select the next phase.
- Press the button
P1
to skip the phase IN PROGRESS.
- Press the button P2 ( ) to confirm.
- CANCEL PHASE -
To cancel an already set PHASE, in progress the next phases
must first be eliminated, therefore select the last phase and press
the button
P3 ( ) and confirm with P2 ( ) to cancel it, repeat
this operation until reaching the phase to be eliminated.
- DELAY START - (delayed cycle start)
After setting the TIME (refer to par 4.6.4) carry out the following:
1) Turn knob K to select the DELAY START symbol
D
in the phases field.
5) Press the button
P2 ( ) to select the TIME field .
6) With knob K set the required START time and press the START/
STOP button.
Now the cycle will start at the set DELAY START time and the
letter D goes to the left at the beginning of the PHASE field, indi-
cating this function is active.
4.6 PROGRAM (PROGRAM CONTROL)
Foreword: the PROGRAM control is used for storing the cook-
ing cycles after setting them manually; for that purpose, first see
par. 4.3 AUTOMATIC or 4.4 MANUAL, it also allows already ar-
ranged programs to be used (e.g. CLEAN).
Note:
If the oven is switched off after manually setting a cooking cycle,
the data of the setting will be lost , because the electronic board
does not memorize the cooking cycle in manual operation mode.
See STORING RECIPES section 4.6.1.
4.6.1 STORING RECIPES OR PROGRAMS
The RECIPES or programs (or cooking cycles) can be
stored in the oven with a number (in sequence) and an
identification description for the corresponding search.
E.g.
01 (RECIPE no.)
COOKING CHICKEN (RECIPE description)
02
COOKING POTATOES