Electrolux 5995502399, Руководство по обслуживанию

Страница: 18 / 173

Installation Information
2-6
To Adjust The Door Stop
Door stop is adjustable between 85 to 145 degrees.
NOTE: Views shown in Figures 2-7 - 2-12 are looking
up at the bottom of the refrigerator door.
1. Open door to provide access to set screw.
2. Loosen set screw. (See Figure 2-7)
3. Adjust door to desired location. (See Figure 2-8)
4. Rotate door stop until it makes contact with the lower
hinge. (See Figure 2-9)
5. Re-tighten set screw.
6. Ensure door stops in desired location before
resuming normal use.
Lower
Hinge
Door
Stop
Set
Screw
Min.
Open
Max
Open
Rotate
Door To Desired
Location
Figure 2-7.
Lower
Door
Door
Hinge
Washer
Raise
Figure 2-11.
Figure 2-12.
Figure 2-8.
Rotate
Door
Stop
Re-tighten
Set Screw
Figure 2-9.
Remove Set Screw
Open
Door
90
Degrees
Bottom of Door
Figure 2-10.
To Level The Doors Using The
Adjustable Lower Hinge
1. Open doors to 90 degrees.
2. Extract set screw from lower hinge. (See Figure
2-10)
3. Lift the door while adjusting washer. To raise door,
rotate washer clockwise (when viewed from bottom).
To lower door, rotate washer counter-clockwise
(when viewed from bottom). (See Figure 2-11)
4. Re-install set screw, ensuring it is between spokes
of the set washer. Set screw will not be tight, just
insert until it is flush with hinge. (See Figure 2-12)
NOTE: If after adjusting doors higher the door makes a
popping/clicking sound, remove set screw and replace
with a longer one.