Electrohome EANOS502, Инструкция по эксплуатации

Страница: 9 / 42

- 9 -
BUTTONS AND CONNECTIONS
POWER SOURCE
This system is designed to operate on normal 120V
60Hz AC only. Attempting to operate this system
from any other power source may cause damage to
the system, and such damage is not covered by
your warranty.
Note: This system is equipped with a polarized
AC power plug having one blade wider than the
other. This is a safety feature. If this plug does not
fit into your existing AC outlet, do not try to defeat
this safety feature by altering the wide blade to
make it fit into your outlet. If this plug will not fit
into your outlet, you probably have an outdated
non-polarized AC outlet. Have the obsolete outlet
changed by a qualified licensed electrician.
BATTERY INSTALLATION OF REMOTE CONTROL
• The remote control requires one CR2025 (3V)
lithium battery.
• Hold level pressing the clasp with the
thumb in the right direction of the arrow
in the illustration, and take out the battery
compartment by sliding with forefinger in
the direction to yourself. Take out the battery
compartment from the remote control.
Install a lithium battery (CR-2025) in the
compartment with the positive polarity
turned up. Hold level and push the battery
compartment into the remote control lightly.
It is okay once you hear a click.
PREPARATION FOR USE
Transit Screw UNPACKING AND SETUP
• Carefully remove the unit from the display carton
and remove all packing material from the unit
• Unwind the AC power cord and extend it to its full
length
• Unwind the FM Antenna wire and extend it to its
full length
• Place the unit on a stable, level surface, close to
an AC outlet, out of direct sunlight, and away from
sources of excess heat, dust, moisture, humidity, or
strong magnetic fields
• Raise the lid to expose the phonograph. The phonograph has been secured for shipment with a transit
screw. Use a coin or screwdriver to TURN THE TRANSIT SCREW CLOCKWISE. This will allow the turntable
to “float” and turn freely.
• Remove the opaque white plastic stylus cover from the
phonograph stylus by sliding it in the direction of the arrow.
• Discard the stylus cover.
• Remove the twist-tie that was used to secure the tone
arm during shipment.
• Release the tone arm lock lever.
• Connect the plug to your AC outlet, as shown below.
PREPARATION FOR USE
Tone Arm
Lock Lever
Stylus
Cover