Electro-Voice XLCi Series, Руководство по монтажу

Страница: 11 / 32

ELECTRO-VOICE
®
X LC i TM Rigging Manual 10
ON EACH ENCLOSURE, ALWAYS MAKE SURE THAT THE LEFT AND RIGHT
REAR CONNECTOR BARS ARE BOLTED INTO THE SAME HOLE FOR THE
SAME VERTICAL SPLAY ANGLE.
MAKE SURE ALL LINKING HARDWARE IS TIGHTENED TO 70-90 IN LBS.
BEFORE ADDING ADDITIONAL ENCLOSURES TO THE ARRAY.
Attach the top enclosure in the array to the grid, as shown in Figure 5b. (Only an X LC i compatible
grid can be used with an X
LC
i array.) The front connector bars bolt through the bottom two holes
on the front of the grid sidearm, and the rear connector bar bolts through the top hole on the rear
of the grid sidearm.
MAKE SURE ALL LINKING HARDWARE IS TIGHTENED TO 70-90 IN LBS. AND
THE QUICK-RELEASE PINS ARE FULLY LOCKED INTO THE SPREADER BAR
BEFORE LIFTING THE ARRAY.
Begin to lift the grid and first cluster. Additional enclosures may be added one at a time, to the
bottom of the first cluster, or additional smaller clusters can be added to speed assembly time
using the previous steps. To disassemble the array, reverse the steps outlined in this section.
Figure 5a:
Flying X LC i Systems - Step 1
Install Finger Tight!
Split Washer (x2)
1.625 in (41.3mm)
long bolts
1.00 in (25.4mm)
long bolts