LX2056 Owner's Manual
Revised November 11, 2015
Page 14
800.445.7846 · www.electro-mech.com
Connecting data cable to the stereo plug requires soldering to two terminals. Slide the
cover and sleeve over the data cable before soldering. The terminal nearer the center
of the plug body connects to the tip of the socket. The black wire from the data cable
should be soldered to this terminal. The terminal that extends further from the center of
the plug body connects to the ring of the plug.
Solder the red wire here. The strain relief tabs
are connected to the shaft of the plug. When
you bend the tabs around the data cable, they
should be in contact with the shielding or the
bare drain wire.
Slide the insulator sleeve over the terminals and
screw the cover in place to complete the
assembly. Now you will be ready to plug the
data cable into the port at the top of the stat
panel cabinet when it is installed.
