Electroair Acquisition Corp.
IM EA-15000
Page 9 of 10
Revision 01
Prepared by: EAC
02/04/2020
Figure 5: Configuration A and B Back Surfaces
4. Final Installation Steps:
CAUTION: If using a non-impulse coupled magneto aka direct
drive magneto aka non-starting magneto, update pilot checklist/
POH to have MAG switch in OFF position during starting.
Start the aircraft per the AFMS and perform a ground run-up.
o
Check for proper starter function.
o
Check for proper RPM drop on Left Magneto.
o
Check for proper RPM drop on Right Magneto.
If the aircraft passes, then return to service.
If the aircraft fails, then verify that all of the connections are correct and
competent and that no other wires were damaged during the install. Repeat the
start-up process.
If the aircraft fails a second time, contact the factory for support. (248-674-3433
or
)
