Electroair Acquisition Corp.
IM EA-15000
Page 3 of 10
Revision 01
Prepared by: EAC
02/04/2020
Overview of Ignition/Starter Switch Panel Installation
Thank you for purchasing an Electroair EA-15000 Ignition/Starter Switch Panel. The
next pages will provide a step-by-step process of installing the Ignition/Starter Switch
Panel on the aircraft. Electroair hopes you will enjoy the experience and that this
manual will provide clear direction and guidance through this process. This manual will
cover the following general installation steps:
1. General overview and recommendations
2. Removal of old ignition components
3. Set-up & installation of p/n: EA-15000 Ignition/Starter Switch Panel
4. Final installation steps
Electroair strongly recommends reading through this entire installation procedure before
installing the Electroair Ignition/Starter Switch Panel to your aircraft. Make sure that any
questions are answered before the actual installation. Also, make sure any extra
components needed, e.g. cable ties, switch terminations, etc., are available. Removal
of old components and installation of new components shall be completed in
compliance with CFR Title 14 Part 43, as applicable, and any Airframe or Engine
Manufacturer Maintenance Procedures, as applicable. Above all else, use good
common sense and professional judgment. An ignition/starter switch panel is an
electrical device. If an ignition/starter switch panel is improperly installed, severe
damage could be caused to the ignition/starter switch panel, aircraft, or installer
including bodily injury or death.
Please contact Electroair with any questions during this installation process. Good luck
and happy flying!!
Electroair
