MM-13- rev 01-EN
28
The parts adjacent to the bearing must also be cleaned well, e.g. shield machined surfaces, covers,
grease boxes, etc., verifying that there are no burrs or damage to the seats. If an emery cloth or a
grinding wheel must be used to eliminate scratches or other problems, pay attention that metal dust
does not deposit in or around the bearings.
Spread a thin layer of grease on the pin surfaces and other parts indicated above to protect them
from corrosion.
Heat the bearing in an oil bath at 70 ÷ 80 °C, mount it onto the seat and hold it against the shaft
shoulder until the bearing has cooled down.
SPARE PARTS
Ordering spare parts
On ordering spare parts, it is necessary to supply a precise description of the requested component,
in addition to the features indicated on the generator rating plate and in particular the generator serial
number.
The type of machine stamped on the rating plate and the serial number allow identification of all
spare parts.
Storage of spare parts
Spare parts must be preserved in a clean, dry, ventilated environment.
It is advisable to check the spare parts periodically to verify their condition.
