Page
8
of
11
MAINTENANCE
Cleaning
ATTENTION: Please shut off the unit and unplug from the mains before cleaning or
performing any maintenance.
Cleaning the surface
Clean the plastic housing with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible
damage. Make sure no water enters the control panel. Cleaning the water tank
Unplug the power cord, remove the honeycomb filter bracket, and then remove the water tank.
With a cloth (dipped in a mild detergent), wipe the water tank, rinse it with water, and then
carefully place it back in the unit.
Draining the water reservoir and refilling with fresh water at least once a week will help reduce
any mineral deposits and keep the filters clean.
Do not run the unit in Humidify mode with stale water in the tank.
We recommend emptying the tank and refilling it with fresh water if water has been standing in
the tank for an extended period of time.
MAINTAINING AND CHANGING THE HONEYCOMB FILTER PADS
The appliance is supplied with Honeycomb cooling / filters pads. The cleaning frequency for the
Honeycomb filter depends on local air and water conditions. In areas where the mineral content of
water is high (hard water), mineral deposits may build up on the honeycomb cooling filter and restrict
air flow. If mineral deposits remain on the Honeycomb pads, the filter should be removed and
washed under fresh water. We recommend cleaning the honeycomb filter at least every two months,
depending on your needs.
For best results, allow the honeycomb filter to dry after each use by turning off the humidify
function for 15 minutes (with empty water tank) before turning the unit off.
Unplug the power cord, then remove the honeycomb filter frame, and take the honeycomb filter
out of the bracket.
With a mild detergent and a soft brush, scrub the honeycomb filter, clean with water and dry
End of Season Maintenance
˖
˖
˖
˖
1. Drain the tank by removing the rubber plug at the bottom
2. Clean the Honeycomb pads
3. On a dry day run the unit in air cleaning mode for 2-3 hours until the inside is dry
4. Resit the clean and dry honeycomb pads back into the unit
5. Cover the unit and keep it in a dry place.
