14
Use a vacuum cleaner to remove dirt. If the dust filter is very dirty, it may be washed in lukewarm
water with a very small amount of neutral detergent. Rinse well and allow to dry completely (not in
direct sunlight or near a source of heat).
Reverse the filter removal procedure and push back the clean filter. Keep the filter parallel with
panel.
Restore the power from the consumer unit and turn the air conditioner on.
INDOOR UNIT:
While the unit is disconnected from power dust regularly with a dry cloth or slightly
damp paper towel. Never use chemicals or solvents. Never spray a liquid in or over the appliance.
OUTDOOR UNIT:
While the unit is disconnected from power, remove dirt and keep the air intake
and exhaust openings free of debris, etc. Cleaning with chemicals may cause damage. Use
professional installers to service the fan or the other parts.
START OF SEASON
If the air conditioner is to be used again after an extended period:
• Check that the air intake and exhaust openings of the indoor and outdoor units are not
blocked. Remove all dirt and debris.
• Check that filter is installed and is clean.
• Check that the condensation outlet drains properly and there is no dirt or organic blockage
(otherwise leakage may occur)
• Install 2 AAA batteries in the remote control.
• Turn the appliance on, set the time and desired setting.
END OF SEASON
If the air conditioner is not going to be used for an extended period:
• Set in fan mode on a slightly warm day so that the inside of the appliance dries out.
• Switch off the power at the fuse box
• Remove the batteries from the remote control.
• Clean the filters.