Elecrow Crowtail Deluxe Kit, Руководство пользователя

Страница: 7 / 47

05
Crowtail bright LED is a bright LED light with high brightness
and a large angle. Then its low terminal resistance can be
applied to indoor lighting, commercial lighting. Unlike colored
LEDs, Crowtail bright led light is white, very similar to our
daily light source and you can use it to make your own table
lamp. It can provide a strong light source for your project,
lighting, or so on.
The Crowtail- Switch is a Latching switch. When the switch is pressed
for the first time, the switch maintains current regulation and the button
outputs a HIGH signal in the self-locking state. When the switch is
pressed for a second time, the switch button pops up and the switch
turns off and then outputs a LOW signal. In fact, it is very similar to the
button, except that the switch has a self-locking function so that it can
output logic high level signal without pressing it all the time.
In this lesson, we are going to use bright LED module and switch to make a corridor night lights,
which will produce a strong illumination light for those who need it. Let’s start playing and see the
difference form colored LEDs.
Lesson 1 – LED Control
Lessons
Introduction
Arduino Uno/Crowduino Uno x1
Crowtail - Motor Base Shield x1
Crowtail - Bright LED x1 Crowtail - Switch x1
Crowtail - Cable x2
Required Parts
STEP1: Plug the Crowtail-Motor Base Shield onto the
Arduino or Crowduino board.
Hardware Connection
STEP2: Connect the Crowtail-Switch and Crowtail-Bright
LED to the D2 and D3 ports of the Crowtail-Motor Base
Shield. The complete connection is as follows.
Open the P01_LED_Control with Arduino IDE
and upload it.