www.elecro.co.uk
8
ENGL
IS
H
Installation Mode
When entering Installation mode the heating device and pump will
immediately be turned off (if they are on) and will not be permitted to
be turned on while the controller remains in any of the setup menus. On
exiting the ‘Installation’ mode the controller will revert to the ‘Normal’
mode and follow the same procedure as if first entering that mode, the
display will reflect this.
• LANGUAGE (English, French, German, Spanish and Russian)
• UNITS (temperature units; centigrade or fahrenheit)
• CLOCK (set current time)
• TIMER (four time settings for switching the heating device ‘On’ and
‘Off’)
• PROBE CAL (Temperature calibration adjustment )
• MODBUS (Set Baud rate, address and parity for BMS connection)
• FACTORY (Access restricted)
• EXIT
Language Setup
Enter the ‘INSTALLATION’ mode by touching the ‘M’ button key repeatedly
until ‘INSTALLATION’ appears at the top of the display then touch the ‘O.K’.
Button key.
