5
Figure 1
Installation
Strip off all of the insulation from 5.5 inches (14 cm) of the supplied hookup wire.
Cut the bare wire into four 1" (2.5 cm) lengths and one 1.5" (4 cm) length.
From the remaining hookup wire, cut two 1.5" (4 cm) insulted lengths. Strip 1/4" (6 mm) of insulation
off each end of both wires.
Solder the two 1.5" (4 cm) insulated wires into the
D
and
5
pads on the KXB30 board, from the
top
side (the side with all of the components).
Flush-trim the leads of these two wires on the bottom side.
Insert the five 1" (2.5 cm) bare wires into the
G, C, B, A,
and
G
pads along the edge of the KXB30
board, from the
top
side. Before soldering, make sure almost the entire length of each wire is extending out
from the top side—the wires should be inserted all way into their respective holes, but no farther.
