Elecfreaks TOOCA Laser 1, Руководство пользователя

Страница: 3 / 32

Firmware Upgrade
Please go to the wiki page via https://www.elecfreaks.com/learn-en/tooca-laser-1, select the updating methods to
download the latest firmware. Save it to TF card and it can be automatically updated after powering on.
For the purpose of engraving or cutting with a laser engraving machine, allow the workpiece to be exposed to the
high-density laser beam emitted by the laser engraving machine. The workpiece may be subject to gasification without
combustion as it is pretty hot on the surface. On the other hand, most workpieces are essentially combustible, which may
be ignited, leading to an open flames and consequently to the machine breakdown and environmental contamination.
1. It is prohibited to store the machine in areas close to combustible and explosive substances, volatile solvents or source of
heat. Instead, store it in a well-ventilated, cool and dust-free place;
2. Make sure that only the specific attached power cord rather than other similar power cords are used during installation;
3. Clean the tripod and laser module with a dry cloth regularly when the power is off;
4. Ensure to run the laser at 0°C-35°C. Operation at sub-zero temperature is prohibited; it is prohibited to run the machine
under wet environment or in thunderstorm weather;
5. Switch off the machine if it is offline for an extended period of time, and unplug the power cord;
6. It is prohibited to come in contact with electronic areas with hands or other tools when the machine is connected to
power supply;
7. Touching any moving parts and laser module while the machine is running is prohibited;
8. Before engraving, place a flat object that cannot be penetrated by the laser, such as an aluminum alloy or stainless steel
plate on the workbench, and then place processing material;
9. Wear goggles to prevent vision damage arising from exposure to the laser spot during laser engraving operation;
10. It is advisable to run the machine under well ventilated condition as laser engraving may generate small amount of
fume or gas;
11. Children under 10 years old are not allowed to run the machine without adult presence, which otherwise may lead to
personal injury;
12. Put in place fire extinguishers in case of use, which shall be regularly checked. It is prohibited to keep the machine
unattended while it is running；
13. Users should comply with the laws and regulations of the corresponding countries and regions where the equipment is
located (used), abide by professional ethics, pay attention to safety obligations, and strictly prohibit the use of our products
or equipment for any illegal purposes. ELECFREAKS will not be responsible for any violators' legal liability under any
circumstances.
User Notice