Eldom Invest NHC-56M, Руководство по эксплуатации

Страница: 6 / 44

Mode „Timers“
This mode allows the user to control the water heating algorithm by using the weekly programmer of the thermoregulator.
You can program with them when switching on the heating element is permitted or the maximum temperature of heating
water. Timers can operate in two ways – by changing the temperature in "Program" mode and by permitting the activation
in "Timers" mode. A mode is selected in "System Setup" menu, "Timer" parameter, as
"Program" mode is set at value
Change.t , and "Timer" mode at value “On/Off” . Each of the seven timers/programs allow the entry of one time interval
and days of the week in which to be active. The "Program" mode also set the temperature to which water will be heated in
the relevant time interval. Outside this interval, the temperature to which water will be heated is the set temperature. In
"Timer" mode the heating element can only be switched on in the set range and will operate until the set temperature is
reached. In order to activate the timers/programs mode, the system clock must be set and at least one timer/program must
be set and active. The thermoregulator displays in the left field information to which temperature water will be heated and
till when that temperature will be valid or when it will be active. When entering the start and end of the time interval, the
thermoregulator will not allow for the end to be before the start.
„Delayed Start“ mode
When the water heater is in „Standby“, by pressing and holding for 3 seconds of ▲ button is
activated the entry of time, in which the appliance will switch on automatically. The time is set with
10-minute increments. A delayed start may be up to 24 hours. When entering the setting of "Delayed
Start", the default time is the current time rounded up to 10 minutes, and the subsequent pressing of
▲ or ▼ buttons can increase or decrease the time by 10 minutes. If any of ▲ or ▼ buttons is held
pressed for longer than 0.7 sec., the value starts automatically to increase or decrease at a rate of 4
units per second. If „Delayed Start“ mode is activated, the middle display field will show the time of
switching on. If correction of already set time for delayed start is required, ▲button should be held
pressed again. "Delayed Start" mode is canceled by pressing 1 button and proceeding to another
mode. In the event of power outage, while "Delayed Start" mode is activated, the controller will save
the time for the delayed start. If the time set comes before power supply recovery, then when the
power supply is recovered the controlled will remain in switched off state.
6
EN EN