Eldes EWR2, Руководство пользователя

Страница: 6 / 14

66 EN EWR2 Wireless Signal Repeater v1.1
NOTE: For a wider wireless signal coverage in the area, place one or several (up to 4 in total) EWR2 devices.
NOTE: Unlike EWR1, it is necessary to bind EWR2 to the system using ELDES Configuration Tool , otherwise the device will not be able to
operate correctly.
ATTENTION!: DO NOT use EWR1 and EWR2 in one system at the same time, otherwise the system will not be able to operate correctly.
4. EWR2 Zones and Tampers
EWR2 is equipped with 2 zones. This feature enables wireless access for to 2 wired devices such as movement PIR sensors, magnetic door
contacts etc.
11
COM NC
NC COM
+VIN GND
Magnet
Z1 CO
M
DC+ CO
M
Z2
5,6 kΩ
5,6 kΩ
Z1 CO
M
+3V
DATA
CO
M
DC+ CO
M
Z2 Z1 CO
M
+3V
DATA
CO
M
DC+ CO
M
Z2
ATTENTION: If you are using the wiring method, described above (Figure No. 11, right - sided), keep in mind that in case of main power loss,
EWR2 will keep on functioning (using backup batteries), thus it won’t be able to charge any other exterior devices.
In case of tamper violation, the alarm is caused regardless of system being armed or disarmed. There are 2 ways to detect tamper violation
on EWR2:
• By tamper switch. EWR2 comes equipped with 2 built-in tamper switches intended for enclosure supervision:
• one located on the front side of the PCB supervising the front cover in case it is illegally opened (see fig. #1).
• the other one located on back of the PCB supervising the back side of the enclosure in case the EWR2 is illegally detached from
the wall (see fig. #1).
Once the enclosure of EWR2 is tampered, the tamper switch will become triggered. This action will be followed by alarm, resulting in
sending an SMS text message and/or phone call to the user. The SMS text message contains the violated tamper name.
• By wireless connection loss. The wireless connection loss between EWR2 and ELDES alarm system leads to alarm. The system
identifies this event as a tamper violation and sends alarm by SMS text message and phone call to the user (-s) by default. The SMS text
message contains the wireless device model, wireless ID code and tamper name. The user will also be notified by SMS text message as
soon as the wireless signal is restored.
ATTENTION: The tamper will not operate if both wireless zones are disabled.