Eldes EWR2, Руководство пользователя

Страница: 13 / 14

13 13 EN EWR2 Wireless Signal Repeater v1.1
6. ADDITIONAL INFORMATION
Limited Liability
The buyer must agree that the system will reduce the risk of fire, theft, burglary or other dangers but does not guarantee against such
events. “ELDES UAB” will not take any responsibility regarding personal or property or revenue loss while using the system. “ELDES UAB”
liability according to local laws does not exceed value of the purchased system. “ELDES UAB” is not affiliated with any of the cellular provid-
ers, therefore is not responsible for the quality of cellular service.
Manufacturer Warranty
The system carries a 24-month warranty by the manufacturer “ELDES UAB”. Warranty period starts from the day the system has been
purchased by the end user. The warranty is valid only if the system has been used as intended, following all guidelines listed in the manual
and within specified operating conditions. Receipt must be kept as a proof of purchase date. The warranty is voided if the system has
been exposed to mechanical impact, chemicals, high humidity, fluids, corrosive and hazardous environment or other force majeure factors.
SAFETY INSTRUCTIONS
Please read and follow these safety guidelines to safeguard yourself and others:
• DO NOT use the system where it can interfere with other devices - such as medical devices
• DO NOT use the system in hazardous environments
• DO NOT expose the system to high humidity, chemical environments or mechanical impact
• DO NOT attempt to repair the system yourself - any repairs must be carried out by fully qualified personnel only
The EWR2 can be powered by a 9-15V 300mA DC power supply unit, if no additional devices are connected. The device is not meant for
outdoor use, i.e. you should use it inside a building and the power supply unit must be plugged into a standard Euro 2-pin socket or UK
3-pin socket (depending on the version of power supply unit you have bought). When connecting the power supply, mind the polarity
terminals. DO NOT switch the polarity terminals places. The main circuit should be protected by short circuit or over-current protection.
Please use the power supply that meets the EN 60950-1 standard. Any additional device you connect to the system, such as a comput-
er, must also be powered by an EN 60950-1 approved supply.
Disconnect the mains power before installing. Never install or carry out maintenance during stormy weather. The electric socket that
powers the device must be easily accessible.
To switch the system off, unplug the external electric power supply or power down any other linked device that EWR2 is powered from.
A blown fuse cannot be replaced by the user. The replacement fuse has to be of the kind indicated by the manufacturer (fuse F1 model
– MINISMDC050F 0.5A).
Copyright © “ELDES UAB”, 2015. All rights reserved
It is strictly forbidden to copy and distribute information in this document or pass to a third party without an
advanced written authorization from “ELDES UAB”. “ELDES UAB” reserves the right to update or modify this
document and/or related products without a warning. Hereby, “ELDES UAB” declares that the wireless signal re-
peater EWR2 in compliance with the essential requirements and other relevant provisions of Directive 1999/5/
EC. The declaration of conformity may be consulted at: www.eldes.lt
The WEEE (Waste Electrical and Electronic Equipment) marking on this product (see left) or its documentation indicates that the
product must not be disposed of together with household waste. To prevent possible harm to human health and/or the environ-
ment, the product must be disposed on in an approved and environmentally safe recycling process. For further information on
how to dispose of this product correctly, contact the system supplier, or the local authority responsible for waste disposal in
your area.