Eldes ESIM110, Руководство пользователя, Страница: 5 / 40

MANUAL ELDES ESIM110 V1.0 5
EN
1.4 Connector and LED Indicators Functionality
1.5 Connection Circuit
1.6 System Installation
The system can be installed only in a metal or non-fl ammable plastic enclosure. If the metal enclosure and transformer is used it
is necessary to ground the enclosure using yellow/green colour cable. For the connection of 230V transformer use 3x0.75 mm2
1 thread double isolated cable. The primary circuit of the transformer must be connected through 0.5A fuse. 230V power supply
cables cannot be grouped with low voltage cable group. For the connection of power supply and output connectors use 1 thread
2x0.75 mm2 cable. For the connection of input/output connectors use 0.50 mm2 1 thread cable.
1. Place SIM card in the holder but make sure that SIM card PIN code is disabled (PIN code can be disabled by putting SIM card
into mobile phone and following proper menus). SIM card should not have any remaining SMS messages.
2. Connect the circuit as shown in fi g. No 2. Connect control connectors of the gate automatics device to the relay contacts. The
systems that are already installed most often contain a button for opening the gates. The relay can be connected instead of the
button or in parallel with its contacts.
3. Connect a sensor or switch to inputs Z1-Z3 that turns on only when gates are lifted. Low level signal is connected to Z1 and Z3.
High level signal is connected to Z2. (Input connection is an additional function and it is not necessary to install).
4. The system will start in less than a minute. LED2 indicator should be blinking or be ON indicating connection to GSM.
Short explanation of the main units
GSM MODEM GSM network 850/900/1800/1900 MHz modem
SIM CARD SIM card
LED Light-emitting diodes indicator
DEFAULT Connectors (D1 and D2) for restoring default settings
ANT GSM antenna SMA type connector
USB Mini USB connector
Connector functionality
Labeling Explanation
AC/DC Power supply pins
RELAY Dry relay contact. Normally open (NO)
RELAY Dry relay contact. Normally open (NO)
COM Common pin
Z3 “Low” level input Z3
Z2 “High” level input Z2
Z1 “Low” level input Z1
Fig. No 1
ANT
GSM
MODEM
SIM
CARD
MIC
LED1
LED2
DEFAULT D1 D2
AC/DC
RELAY COM - - Z5 Z4 Z3 Z2 Z1
USB
ESIM 110
AC/DC
Power
supply
Gate controller
+
-
RELAY COM Z3 Z2 Z1
Fig. No 2
NOTE
Although the installation of system Esim110 is not complex, we highly
recommend installing the device only in the case if you have minimal
electrotechnical or electronics knowledge. Otherwise you can damage
the device.
LED indicators functionality
LED1 Indicates SIM card
status
LED2 Indicates network
status
LED1 status Meaning
OFF SIM card is wor-
king properly
ON SIM card
error
LED2 status Meaning
OFF No network connection
Blinking 1 times per second Poor network connection
Blinking 3 time per second Medium network connection
ON Excellent network connection